A2TM – Advancing Air Temperature Metrology Workshop on Air Temperature Measurement
The National Standards Authority of Ireland (NSAI), with support from the Slovak Metrological Institute (SMU), will host an online webinar on Wednesday, 25 February 2025, from 10:00 to 13:00 CET. The event will take place via Microsoft Teams and will bring participants together for a focused morning session of presentations and discussion.
Objective of the A2TM Project
The project will enhance air temperature metrology by developing a highly controlled mobile sub-chamber system (−40 °C to 80 °C) with a target uncertainty of 15 mK. It will control key environmental factors and establish comprehensive calibration and uncertainty evaluation procedures, including interlaboratory comparisons to harmonise practices. The initiative also promotes knowledge transfer and long-term adoption of improved traceability across NMIs/DIs, laboratories, industry, manufacturers, and regulators in Europe.
Objective of workshop
NSAI with support from SMU is hosting an online workshop for the A2TM consortium and stakeholders to share current findings and gather community feedback.
Workshop Schedule (CET)
10:00–10:15 Welcome and A2TM overview – Joshua Walsh (NSAI)
10:15–10:45 Presentation 1: Air Temperature Measurement + Q&A - Davor Zvizdić (FSB)
10:45–11:00 Break
11:00–11:30 Presentation 2: Survey Results on Air Temperature Practices + Q&A - Graziano Coppa (INRIM)
11:30–11:40 Break
11:40–12:10 Presentation 3: Literature Review on Air Temperature measurement + Q&A - Jan Nielsen (DTI)
12:30–12:40 Presentation 4: Sub-Chamber Design + Q&A - Christina Hofstaetter-Mohler(BEV)
12:40–13:00 Open discussion, closing remarks, and next steps (NSAI)
Registration for the Workshop:
[Disclaimer: All reasonable effort was made to ensure that the information on this page was correct at the time of publication. Any views or opinions expressed on this page are not necessarily those of NSAI. NSAI accepts no responsibility or liability howsoever arising from the contents of this publication or any errors, inaccuracies, or omissions in the contents of the information provided therein.]
